ASTM A STANDARD SPECIFICATION FOR STEEL FORGINGS, CARBON AND ALLOY, FOR GENERAL INDUSTRIAL USE (AASHTO NO. M ). ASTM-A ASTM A is forging specification that covers untreated and heat- treated carbon and alloy steel forgings for general industrial use. ASTM A ASTM A, Carbon and Low Alloy Steel, Piping Components, LF1, , . ASTM A, Carbon Steel Forging, A (AH), , , , ,
||18 October 2007
|PDF File Size:
|ePub File Size:
||Free* [*Free Regsitration Required]
ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Land Use and Development. By joining you are opting in to receive e-mail. Rough Forging Sketches A dimensioned sketch or drawing of the proposed rough forging shall be supplied by the producer for approval before the forging is produced.
X668 any combination of tap size and pin diameter shown, the pin in double shear will develop the strength of the rod if both the rod and pin are made atsm steel having the same physical properties. Defense manufacturing is all about project manufacturing and project accounting. Promoting, selling, recruiting, coursework and thesis posting is forbidden. Magnetic Particle Test S6. Copyright Compu-tecture, Inc. The values stated in each system may not be exact equivalents; therefore, satm system shall be used independently of the other.
Common Forged Material Comparison Chart – Buford, GA – CAB Incorporated
The tensile properties shall conform to the requirements for the class of forgings ordered Class A. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address xstm below. Atm shall apply only when speci? Current edition approved March 1, Link to Active This link will always route to the current Active version of the standard.
Forged Material Comparison Chart
Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or a6668 phonefaxor service astm. Search book title Enter keywords for book title search.
If inadequate, a larger diameter pin must be selected.
Register now while it’s still free! Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
The results shall meet the requirements of Table 2. If someone was to use AISI to make forged steel items, how would the properties compare with forgings made of A?
Last previous edition approved in as A — Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Download Now White Paper: It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
Part Clevis D N Thd. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
However, the test depth shall not be nearer to one heat-treated surface than 3? Download Now Defense manufacturing is all about project manufacturing aatm project accounting.
If a standard grade has been used to manufacture the forging the permissible variations in composition of Speci?
Materials shall be forged by hot mechanical work. Details of these supplementary requirements shall be agreed upon by the manufacturer and the purchaser.
Except for Class A, all forgings shall be heat treated, depending on class, by the following techniques: Steel specimens shall undergo heat and product analyses, and shall conform to required chemical compositions for manganese, phosphorus, and sulfur. For untreated forgings Class A weighing less than lb [ kg] each, one test from each heat shall be made.
Ordering Information and General Requirements 4. The Eng-Tips staff will check this out and take appropriate action. Remember me for one month. The pin must be investigated for bending. For Grade X2 closest totypical limits are 0. Combining values from the two systems may result in nonconformance with the standard.
Please login to your authorized staff account to use this feature. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?